Welcome, Guest

Welcome to TeslaSCADA

Connect TeslaScada IDE to M221 PLC siulator

Welcome to TeslaSCADA forum!

Tell us and our members about your experience of using our products.

Page:
1
2

TOPIC: Connect TeslaScada IDE to M221 PLC siulator

Connect TeslaScada IDE to M221 PLC siulator 2 years 10 months ago #1681

miftahuda Offline New Member Posts: 12 Karma: 0	Why when choosed Holding Coil, Bit input menu did not active? tq
	Last Edit: 2 years 10 months ago by miftahuda. The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 2 years 10 months ago #1682

miftahuda Offline New Member Posts: 12 Karma: 0	Why when choosed Holding Coil, Bit input menu did not active? tq
	The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 2 years 10 months ago #1683

fatkhrus Offline Administrator Posts: 855 Thank you received: 126 Karma: -108	Because Holding coil is one bit register. There is no need to choose bit. Best regards, Ruslan
	The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 2 years 10 months ago #1684

fatkhrus Offline Administrator Posts: 855 Thank you received: 126 Karma: -108	To set up %M1 and %M2 setup offset 1 and 2 accordingly in Pointer settings. You can use up to 16 tags free without buying a license. Best regards, Ruslan
	The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 2 years 10 months ago #1685

miftahuda Offline New Member Posts: 12 Karma: 0	ok well done for %M0, %M1 and %M2 Tq Ruslan
	The administrator has disabled public write access.

Page:
1
2

Welcome to TeslaSCADA

Connect TeslaScada IDE to M221 PLC siulator