TOPIC: Monitoring communication CLP ControlLogix

Good Morning.
In bench tests created a tag on my ControlLogix PLC as Bool being controlled between 1 and 0 for my smartphone where I have installed teslascada2, which created a momentanio button. This working perfectly for my writing on my smartphone PLC tag however if I lose communication of my smartphone this pemanece tag 1 in my PLC.
My doubt is:
I would like to monitor the communication between the TeslaScada2 and my ControlLogix PLC? Since the loss of communication zero the value of the tag?

Hello,
I'm not sure I correctly understand your questions. When your lost communication between your PLC and smartphone you'll get notification about that with dialog box and sound signal. Also all tags bind to this PLC should zeroed on your display, but it couldn't be zeroed in your PLC because connection is lost.

Best regards,
Ruslan

yes in your program I get the lost connection of alarm, but when there is this loss of communication has as I tell this to my ControlLogix PLC, thus resetting the values to the PLC that was caught value?

If you lost connection it's not possible to reset values on your PLC. You should reconnect to your PLC and only then change values.

Best regards,
Ruslan

OK Ruslan.
Able to make a communication between check ControlLogix PLC and the teslascada2 this on my smartphone. by a script in teslascada2 which created an input connected to an output. if you want to send you email explaining better. so whenever I lose communication tag is reset in my PLC.