Welcome, Guest
Username: Password: Remember me

TOPIC: How to send modbus rtu command to device

How to send modbus rtu command to device 2 months 1 week ago #1526

  • fatkhrus
  • fatkhrus's Avatar
  • Offline
  • Administrator
  • Posts: 507
  • Thank you received: 69
  • Karma: -110
David,

You have to setup Control property in Slider: teslascada.com/HTML/control-(for-sliders).html
Minimum: 0, Maximum: 255. And test it in TeslaSCADA2 Runtime.

Best regards,
Ruslan
The administrator has disabled public write access.

How to send modbus rtu command to device 2 months 1 week ago #1527

  • davidtsai
  • davidtsai's Avatar
  • Offline
  • New Member
  • Posts: 8
  • Karma: 0
Ruslan:

Yes ,I had add slider value from 0 to 255 , but our teslascada2 still can't send command to our device when I monitor the information of modbus 485, my simple modbus command such as below
01 10 27 10 00 01 02 00 FF (01 my device ID ; 10 27 my address of register 10000 start ; 00 01 my quantity value ; 02 my data quantity ; 00 FF my device change value) , follow your command and I still can't depend on teslascada2 to operate my device , How do I do ?

david
Attachments:
The administrator has disabled public write access.

How to send modbus rtu command to device 2 months 1 week ago #1528

  • fatkhrus
  • fatkhrus's Avatar
  • Offline
  • Administrator
  • Posts: 507
  • Thank you received: 69
  • Karma: -110
Do you use TeslaSCADA2 Runtime to connect to your device?
Can you read registers from your device? Try to check communication by using Wireshark.

Best regards,
Ruslan
The administrator has disabled public write access.
Go to top