Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
Main Forum
Welcome to TeslaSCADA
Connect TeslaScada IDE to M221 PLC siulator
Welcome to TeslaSCADA forum!

Tell us and our members about your experience of using our products.

TOPIC: Connect TeslaScada IDE to M221 PLC siulator

Connect TeslaScada IDE to M221 PLC siulator 3 years 11 months ago #1681

  • miftahuda
  • miftahuda's Avatar
  • Offline
  • New Member
  • Posts: 14
  • Karma: 0
Why when choosed Holding Coil, Bit input menu did not active?

tq
Last Edit: 3 years 11 months ago by miftahuda.
The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 3 years 11 months ago #1682

  • miftahuda
  • miftahuda's Avatar
  • Offline
  • New Member
  • Posts: 14
  • Karma: 0
Why when choosed Holding Coil, Bit input menu did not active?

tq
The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 3 years 11 months ago #1683

  • fatkhrus
  • fatkhrus's Avatar
  • Offline
  • Administrator
  • Posts: 984
  • Thank you received: 134
  • Karma: -103
Because Holding coil is one bit register. There is no need to choose bit.

Best regards,
Ruslan
The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 3 years 11 months ago #1684

  • fatkhrus
  • fatkhrus's Avatar
  • Offline
  • Administrator
  • Posts: 984
  • Thank you received: 134
  • Karma: -103
To set up %M1 and %M2 setup offset 1 and 2 accordingly in Pointer settings. You can use up to 16 tags free without buying a license.

Best regards,
Ruslan
The administrator has disabled public write access.

Connect TeslaScada IDE to M221 PLC siulator 3 years 11 months ago #1685

  • miftahuda
  • miftahuda's Avatar
  • Offline
  • New Member
  • Posts: 14
  • Karma: 0
ok well done for %M0, %M1 and %M2

Tq Ruslan
The administrator has disabled public write access.

Connect TeslaScada IDE to CXone Omron Simulator 1 month 1 week ago #3580

  • miftahuda
  • miftahuda's Avatar
  • Offline
  • New Member
  • Posts: 14
  • Karma: 0
dear ruslan,
i'd try to connect cx one omron simulator with finsethernet protocol.
in teslascada, what protocol for omron plc that correlated the protocol below (attached file)?
i attache file below

what;s the different error problem below:
1. can not connect to the server!
2. connection lost!

pls advise to solve the problem

thank you so much
huda
Attachments:
The administrator has disabled public write access.
Forum
Main Forum
Welcome to TeslaSCADA
Connect TeslaScada IDE to M221 PLC siulator
Go to top